How to Convert Your Badge to Velcro for a Flatter Wallet
A wallet clip or pin can hold an otherwise flat badge away from the leather. Taking off that hardware and fitting thin Velcro can help the badge sit lower in its recess and still lift out when you need it. At Hammer & Axe, we put the soft loop on the badge and the rough hook inside the wallet on a leather backer. Here’s how to decide whether your badge is a good candidate and set it up for a flatter carry.
Check how the hardware is attached

Take the badge out and look at where the clip, pin or post joins the metal. Start with the Badge Attachments page if you’re unsure which fitting you have. A removable clip on a badge you carry only in the wallet is a good candidate. If you still wear the badge on a uniform, keep the fitting you need. For an issued badge, check with your department before making a permanent change.
Remove a suitable clip with pliers
Set the badge face down on a clean, folded cloth so you can support it without marking the finish. If you’ve confirmed the clip is designed to come off, grip the clip with a pair of pliers and ease it in the direction it releases. Keep the pliers on the clip to avoid marking the face or bending the badge. The workshop video shows an example of a clip removal.
If the mount is soldered or riveted to the badge, or if it takes force to move, send us a photo or check with the badge maker. A screw and post can also leave a fixed post behind after you take off the nut. Our guide to pins, clips, screws and Velcro explains those fittings. For a Velcro conversion, you want a smooth landing area without a sharp point or a raised part under the pad.
Apply soft loop to the badge and hook inside the wallet

Choose a thin adhesive Velcro pair suited to the mounting surfaces. The badge side needs an adhesive that works on its metal finish. Inside the wallet, an existing hook backer is ready to use. If you’re adding the hook yourself, use a pad approved for the surface of your leather backer, or ask us about a compatible backer for your wallet.
Dry fit the two pieces first. Trim the soft loop to stay inside the badge outline and place the rough hook on the corresponding spot on the backer. Aim for one even layer with enough contact to support the badge. Prepare both surfaces as directed, then peel the liners and press each pad firmly onto its own surface. Give the adhesive its full bonding time before joining the pieces or pulling them apart. The VELCRO Brand application guide explains how surface preparation, pressure and setting time affect adhesion.
Check the fit before you carry it
Once the adhesive has set, line the badge up in the cutout and press it onto the hook. Close the wallet empty first, then add your usual cards and check again. A badge can still sit high because of its curve, while the cover and card stack each contribute to how thick the closed wallet feels. If you still feel a lump, our badge wallet bulk guide can help you narrow down the cause.
If you’d like a hand, send us a photo of the front and back of your badge and tell us which wallet you have. We can help assess the hardware and suggest a backer. When you order a new wallet with a compatible badge, choose Velcro Loop (Velcro Hook in Wallet) in the attachment menu.




Comments